Skip to main content
skill CX Codex

hookup — Claude Code skill: Jeep hookup and installation

The hookup Claude Code skill guides setup of an Arduino Nano on a 1991–95 Jeep diagnostic connector. It walks through wiring and the first read from the engine computer.

GPL-3.0 ★ 319 updated 2026-11-10

Install into Claude Code · Skills CLI (Vercel) All methods and platforms ↓
npx skills add MZULALI/xj-scanner --skill hookup -a claude-code
Open on GitHub

What hookup does

The skill guides the setup of an Arduino Nano scanner for a Jeep, from a laptop check to the first engine-computer response. It has the agent test the laptop-side script, load a sketch onto the Nano, then assemble and label three wires. The laptop steps use Python 3 and packages from pc/requirements.txt; uploading the sketch requires arduino-cli.

A multimeter is used to identify the connector cavities before anything is attached. The wiring values come from one car, so they need confirmation on the Jeep being worked on. After the first connection, the scanner reads fault codes and live values; the walkthrough also flags fuel-trim and speed readings that can be misleading.

What it helps with

  • test the laptop-side scanner before connecting the car
  • upload the sketch to an Arduino Nano
  • assemble and label the three scanner wires
  • identify diagnostic connector cavities with a multimeter
  • read initial fault codes and live engine values

Example prompts for the agent

  • Walk me through connecting an Arduino Nano to my Jeep’s diagnostic connector.
  • Help me rebuild the scanner wiring and identify the connector pins.
  • Show me how to read the first engine fault codes.

How to install hookup

1Skills CLI (Vercel)

npx skills add MZULALI/xj-scanner --skill hookup -a claude-code

2Manually: put the files in place

~/.claude/skills/hookup/SKILL.md

Copy the whole skill folder; for one project use .claude/skills/hookup/

Step by step, with commands for each platform: How to install skills in Claude Code: five ways

Questions about hookup

How do I install hookup in Claude Code?

Run npx skills add MZULALI/xj-scanner --skill hookup -a claude-code. The skill file is at ~/.claude/skills/hookup/SKILL.md.

What does hookup do?

It guides setup of an Arduino Nano scanner for a 1991–95 Jeep, including wiring checks and the first read from the engine computer.

What does hookup require?

You need an Arduino Nano, Python 3 with the packages in pc/requirements.txt, and arduino-cli to upload the sketch. A multimeter is used to identify the connector cavities.

Similar skills

SKILL.md skills catalog →

From the same set3

Project sponsors

Companies that keep this analytics open